DC2 K24 Turbo Project


Look at that clean suspension! Tidy!

I'll rebuild your box for you Matt - I have the best parts in trade!

DSCF0024.jpg
 
DV8 said:
Look at that clean suspension! Tidy!

I'll rebuild your box for you Matt - I have the best parts in trade!

DSCF0024.jpg
Click to expand...
Looks good might take you up on that, they must be them low friction gearsets with the extra bhp coating.
 
msc52 said:
Looks good might take you up on that, they must be them low friction gearsets with the extra bhp coating.
Click to expand...

Yeah, the gears spin much more freely without teeth!
 
DV8 said:
Bought a bunch of fittings from them. Nearly half the price of others and still excellent quality (from a non engineers point of view of course)!
Click to expand...
They do look good quality just trying to work out what ones I need for brake lines, might have to email them.
 
Got started on the wiring on the weekend thanks to my brother for doing this, I would probably wire the engine in to the rear lights:)) anyway removed the dash thought this might be tricky but 8 bolts later and some plugs removed the dash was out, I not going for a full wire tuck just the wires to the head lights and tidy up the engine harness will post some more pic's when done.


Also bought this because I am removing the ABS its a adjustable brake bias valve I am going to mount it under the centre console so it can be adjusted from inside.
 
  • Like
Reactions: rvm
vag_to_jap said:
Very interesting build, Cant wait to to see the finished product!
Click to expand...

Thanks, its been nearly a year so I would like to see it finished now!! trouble is you always find something else to change.
 
  • Like
Reactions: rvm
What's that Matt?!!..... Brembo...... 4pots..... Stainless steel Pistons...... Gleaming red????
 
Not much to tell you at the moment, the caliper's turned up but I don't think they will fit with out running 15mm wheel spacers, so I am just going to buy the yellow speed kit. got to take the engine and gearbox out and finish off the exhaust down pipe and rebuild the gearbox with a LSD.
 
msc52 said:
Not much to tell you at the moment, the caliper's turned up but I don't think they will fit with out running 15mm wheel spacers, so I am just going to buy the yellow speed kit. got to take the engine and gearbox out and finish off the exhaust down pipe and rebuild the gearbox with a LSD.
Click to expand...
Good news for me though!!!
 
  • Like
Reactions: rvm
Little bit of news just test fitted the driveshafts and they seem to fit got about 3mm of play when the shafts are level, ie at there most compressed position, this is good news because I am using Honda CRV front uprights with the 36mm hub nut, I have used a ep3 type r N/S shaft and a dc5 O/S shaft with out having to swap the joints just plug and play.
 
You must log in or register to reply here.
Back
Top