I have a problem with CEL comes one once awhile but goes away when switch off and switch back on. However recently the engines starts to dies off suddenly during idling or during driving. I decided to perform check code process. I pull out the socket and place a wire between the socket pin and...
EK9 original rim comes with offset 50..... CL1 rim offset is 55 width is 6.5. So I am not sure if it fit good with full swing left n right with still some clearence.....
Hi, I own a Ej or EK4 which I have converted to EK9 5 lugs knuckle for both front and back. I wonder if CL1 rim is able to fit without any modification n does not rub when turning the wheels max left n right. CL1 rim specs 16 x 6.5 offset 55.
Mine is a EK 4 door sedan and I am wondering if DC2 center pipe can be used on my EK and also if the rear DC2 muffler can also be fitted in with only minor bracket modification. Any takers?
I would like to know for DC2 Type R 96, what is the RPM reading when the speed is at 100KMH?
I have implant B18C R engine into my EJ and use back the original EJ speedo meter (with minor modification). My RPM reads at 3500 when cruise at 100KMH.
Hi,
I am seeking some advise of which ECU is best for performance for chipping (P28 or P72) as to replace P73? I have convert my Engine D16 with B18C-R plus whole wiring. I am in tropical climate with fuel RON95 or RON97.
I have install B18CR engine into my EJ and I plan to have open port filter set up in my car. Can someone let me know what would be the optimum air intake pipe diameter size that I should have it custom make? Would 3" or 3.25" or 3.5" be fine? Thanks.
I have install B18CR engine into my EJ and I plan to have open port filter set up in my car. Can someone let me know what would be the optimum air intake pipe diameter size that I should have it custom make? Would 3" be fine?
My car is in progress on changing EJ engine to B18CR. I would like to use back the original EJ meter gauge and wonder if anyone can to advise me how it is done.
I just gotten myself a Teg 16" rims with 5 lugs like xristos but the offset is 50. For 16"X7 with such offset will it rub on the body of the car? How to overcome this? I learn that offset 40 is optimum for EK.