Search results

Its an ek9 in kmh, though previously converted to mph, ive removed the converter though.

OK, so checked all the wires with a multimeter, they seem all fine, but through three speed sensors, I still have no speedo. The power is getting 12v, the earth is doing its job fine, other than the signal wire which is sending a constant 4.5v back to the ecu plug whether spinning or not. I'm...

So ive narrowed it down to the power cable, strange as you'd think other sensors would run from the same cable, guess I now just need to take a power supply from another sensor, or the ignition barrel.

Aye that's my first point of call, however - using a multimeter on the signal wire could be quite difficult? Unless I spin the gear on the vss at speed whilst its plugged in? And I assume it would need a power supply and earth to do so?

Hi there, Got a problem with my VSS wiring. As the story goes, my speedo started behaving erratically about two months ago and inevitably stopped working, and would, after a while driving, throw CEL/EML code 17 for VSS as predicted. I replaced the sensor and nothing doing, but I noticed the...

Hi, name's Dan. I'm from Guernsey in the Channel islands. Just bought my first ek9 last October following ownership of my ep3 for two years. Had a glanza before that, but that's in the past thankfully, let's not return there... The 9's reg was previously K9 DYX before being registered on its...