Search results

Do you know if the aftermarket CAT, is a straight swap? M2 do a sports CAT, same length, the only caveat is the flange holes not mating up?

I will put some CAT cleaner through the tank, and get the car upto temp, and then test the emissions again. I'm working away at the moment, so it's difficult organising anything.

I've searched on the Internet , other forums in the US, are also calling it air mixture screw as well, I did think that was only on a carburettor? I've had few chances to buy a second hand Cat but all over £200 to much of gamble.

Yes emission tester, I don't think it was up to normal driving temperature at that time, I cannot remember? The Cat is the original one , I will try some cleaner, then I'll have to take the CAT off. Before I fitted the new O2 sensor the other two readings were also in the red, I was kinda...

I've tried to take two out already and both have snapped, if you have a set, send me a PM, I'll need them, thanks.

If the standard air intake elbow pipe was loose where it slides onto the throttle body, would that throw the reading out? Also the car has done less than 100km since 2013 would that have anything to do with it?

Just an update I've had the car on the tester and a new O2 sensor almost cured the emissions but still running rich (see the top reading) any ideas, the main mechanic is on his holiday at the moment , Do you think it is the air mixture screw on the throttle body ? The car runs fine,idles fine...

Yes b16b, I've had a quick search on the Net, nothing conclusive yet..

Afternoon, Can anyone tell how far (once screwed right in) how many turns to wind it back out the factory setting ? I thinks it's air mixture screw on the throttle body see picture. Also I have attached another pic, How do to remove the scuttle panel plugs/fixings without breaking them.

Have you topped it too much? Or airlock?

There is plenty of EK's getting broke up in the UK, Have you tried ebay UK ? There is one ek9 shell on ebay for sale.

Have you checked the wiring? Bad earth?

Thanks for that. It sounds the better option than a second hand CAT

What's the difference between 200 cell and 400cell? Power output effected? V bands you mean this part circled? Thanks

OK, I'll see how I get on with integra CAT. I could do with knowing , if it is working for a M. O. T.

Revival, I've been offered a jdm integra catalytic converter for my ek9. My whole system is standard. My original CAT is shot is the integra type r CAT, a straight swap? I wanted to buy a new 400cel CAT of ebay but I would need to cut the old flanges off and weld the flanges onto the new...

I petty sure the material that is used in the standard ep3 seats (red) is the same, you could buy a knackered seat for the centre section.

Yes, thats the one, replace, trial and error they aren't expensive, also here is a video to check the throttle position sensor . When was the fuel filter last changed?

Hi, Does the car rev freely in neutral? Maybe wiring issue /VTEC solenoid, Have you checked the wiring to the solenoid As above, check injector/s, Also the map sensor on throttle body.

I feell for you, sickening. Has it kinked any of the inner wing? , subframe OK?