stevenEK9
trackattack
- Joined
- Mar 11, 2007
- Messages
- 4,250
Next oil change before the car goes back on the road i'm looking to redo where my gauges take feeds from as i would like to remove the sandwich plate to maximise oil flow and remove the slight restriction the plate causes
Oil temperature will be taken from the sump (moroso sump so have a port there already)
Oil pressure however trying to work out a suitable place..........
Seen this picture before and always assumed you could run it off the bolt hole on the front left of the head
However looking at the parts catalogue Honda list this bolt as "bolt, sealing, 10mm" and as far as i'm aware the sensors for most gauges are 1/8 NPT threads?
Would i just require a M10 male to 1/8 female adaptor?
Any help would be appreciated
Steven
Oil temperature will be taken from the sump (moroso sump so have a port there already)
Oil pressure however trying to work out a suitable place..........
Seen this picture before and always assumed you could run it off the bolt hole on the front left of the head
However looking at the parts catalogue Honda list this bolt as "bolt, sealing, 10mm" and as far as i'm aware the sensors for most gauges are 1/8 NPT threads?
Would i just require a M10 male to 1/8 female adaptor?
Any help would be appreciated
Steven