Search results

ok So i finally did it right this time. I turned it the correct way and greased the bushing and bracket. But how come my OEM endlink is not perfect parallel to the ground? like going straight down instead of curving. THe sway bar is the EK9 bar.

lol im such an idiot, i think i got it upside down. =D

guys maybe i installed the sway bar wrong? According to some picture i found online, it matches the way i have it. BUt on the ASR instruction, its upside down. Could you look at your Ek9's rear sway and tell me if mine is correct or not?

i forgot to say that i sprayed it with WD40 while the bushing and bracket are installed on the sway bar. i sprayed it at the edge and let the liquid drip in. I was too lazy to unbolt it.

hey rvm, i looked at the rear sway bar from the outside and do not see any tear. I did not jack the car up and look under though. Also i used WD40 (we use this alot in the US) and spray around the bushing and bracket. Then i took the car and made a couple of U-Turns at 25mph. The 1st time i can...

Dino, can you re-explain your instruction? I cannot follow it. So you said i need 2 jack stand, do you mean jack stand or floor jack? floor jack is to raise the car up from 5 inches to 20 inches. Jack stand is to just hold the car up after using floor jack. In your instruction you keep saying...

wat if i see no sign that anything is wrong? think it will be ok?

do i have to take off the ASR subframe brace to look?

i have a question about the rear sway bar. I have the ek9 rear sway bar with OEM bushing and bracket and using the ASR subframe brace. I installed it on a USDM 1998 hatchback. After i installed it and make turns, sometimes i can hear creaking noises? its like its comming from the chassis or...

i am not sure if the bolt is mild steel, it is from ASR subframe brace kit.

hey guys, today i finished installing my ASR subframe brace with the EK9 22mm sway bar using OEM bushing and bracket and endlink. THe problem is that the really long screw that ASR supplied for the LCA is kind of short. The screw on the right side for the LCA sticks out about .9cm at the other...

hey guys, how do you remove the axle back exhaust? I mean remove the side of the exhaust thats from the lower control arm to the rear. I am able to remove the 2 screws that connect the exhaust pipe but I am having trouble removing the 2 exhaust rubber hanger. How do u remove them?

what is antisize? is that in the UK? im thinking of silicone grease for everything

thanks!

im putting on the ek9 sway bar with that brace by the way, do i need to grease anything? im using the OEM endlink and bushing and bracket

ty! i got it

Ok i think this is how u do it, can u check for me to see if the step is correct? #1) I take the THICK L shape bracket and screw one to each side of the ASR Subframe brace. I use the 2 tiny screw to screw it like in the PICTURE with these SIDE facing the correction direction? By the way, DO I...

btw i am still confuse reading your instruction pimpingiron. can u give it in steps?

thansk alot pimpingiroN!!!!! it helps, but in the picture i dont see the really thin bracket. THis bracket

but in this pix (Mixwell), i cant see the thick L or C shape bracket and the thin bracket, I want to see them both so know where it goes exactly and which direction it should be at