Search results

Hi all last year I re bushed all new bearings and ball joints on my car and I used cheap front upper arms why I had blue print ones on order. Within less that a month 200 mile I chewed up the ball joints thought it was just because they were cheap so put on the blue print ones and recheck all...

hi all im looking for a ek9 drivers side upper rear camber arm dont mater if bushes are no good.

Hi all im just replacing my wheel bearing on my ek9 and wondering if anyone knows the torque setting for the big nuts that holds them in place both front and rear? thank in advance

Hi, Im after a horn relay for my ek9. Wanting to see if anyone has one to sell or knows of where I can get one cheaper than what Honda sell them for. The description on it is Mitsuba rc-5001 12v no 96u. Thanks

Hi, iv got a second car that i want to insure as a run about. My insurance wont insure me on it. Do any of you know an insurance company that will mirror your no claims over onto another car as well as my 9. My insurance company said there is a few out there that will do this but never mentioned...

Here some pic from the weekend of modified nationals hope you like. sorry the pic's ant the best. updated more pic's on page 2

Hi everyone, I've been on here for a while but never put any pictures up because I couldn't figure out how to! lol I have had the car for 2 1/2 years now and am still loving it! Here's my car and different pictures of stuff I've done to it ... Engine Bay when I first got it...

Hi all. Im looking for some rear control arms as my bushes have gone on my standard ones on my ek9. Iv been doin some research and from what iv found buddy club and function 7 look the best. Which one wud you recommend and are they suitable for standard honda access suspension or are they...

Hi all i need a new distributor mine has just died :( and i just been up honda for a price £448.47:shocked:. My question is are there any good none genuine distibutors out there that any of you have tried? If so what make was it and how much did it cost? Or if any of you know somewhere that...

Im in need of a new lamba sensor, not sure what make would be best to buy? any suggestions?

is anyone going to modified nationals at peterborough this year on 27 28 29th of may? me and a few mates are having a stand if anyone wants to...

can anyone help me because i can't get my car to communicate with my elm5 scan (diagnostics interface).:angry: I've tried using pcm scan,scan xl,scantool.net and proscan, protocol it not detected through any of the software. i have the 3pin - 16pin connector aswell. (do i need to use the...

hi just wanted to see if anyone is go trax at silverstone this sunday

hi dose anyone no what valve clearaces gap should be for a ek9 b16b as im going to ajust mine tomorrow thanks.

hi is anyone going to modified nationals car show at peterbough on the 28 29 30 may

Iv just had the tracking done on my ek9 and it seems to be pulling to one side worse than it did before. Any ideas why it could still be pulling?

Hi, iv recently brought an ek9 and im not sure which oil is best to put in it. Its completely standard all by an exhaust, its a T reg 99' and has done 65000 miles. Can you help? :please: