Search results

I'm thinking of upping the k20 to a k24, I'd prefer to buy a bottom end but will buy a complete engine if needs be... Thanks

Thought id pop this up on here for you all to see :) Had my integra for a year now, bought it in a bit of a mess tbh and tidied it up a lot in the space of 6 months, did a couple of mods and started to get into drag racing... Before the end of the year my best time was a 13.8 with the B18...

Need another set of calipers for my teg, so I need some 282mm calipers. Would take the discs and pads too if 4x114... I would prefer collection and also to be in the lincs/Norfolk area please :) Would also take a full 5x114 set up with wheels if you were fairly local Tom

Need a 3" backbox fairly urgently, got a 3" system and its like a buddyclub spec2. Needless to say its far to loud. Doesn't matter too much on fitment as it can be modified to suit my integra... Thanks Tom

Going a bit mad trying to work out how to wire a uk narrowband lambda with a k20 swap loom on a pra ecu... So looking for the above to sort out the problem hopefully... Tom

Basically looking for some help, this is my first car gearbox build so please bare with me... I have basically rebuilt my DC5 box and was wondering when everything is back in the casing, should it spin freely by hand? Or should it be fairly tight? It spins when i put the gun on the...

Hi need a cheap k20 box please not bothered if its dead I only need the 2nd gears out of it... Thanks tom

Hi there, I am doing my K swap at the minute, and i am a little stuck with the wiring. I have been on the hybrid racing site for the guide, and it says european wiring looms and ecu's only run the narrow band afr sensors... I was just wondering what people do to get round this? Thanks Tom

I need one of these or an EP3 box with an LSD... Prices posted please :) Tom

As above would like a set of these, preferably 16" and 4x114 but im willing to take other sizes and fitments... Tom

As above please, price and pictures please...

Hi all, Need a integra 96 spec driver side shaft, the short one, as close to pe12 as possible as i will need to collect asap... Thanks muchly Tom

Need some of the above, please as i cracked my rota's somehow :( Cheers Tom

I need a new one as my current one, i think, is the culprit to my sucked up radiator pipes... Tom

Hello all, Looking to strip out my teg and am looking for some bucket seats for the front two. Also some harness' to go with them... Would also have a full recaro interior i could offer up in p/x if anyone was interested... Hit me up with what you got... Tom

Hi all, My box needs replacing so i am looking for a cheap s80 box. So hit me up with what you got and prices please... Thanks Tom

Ideally looking at putting a k20 in my teg, so i am looking for a K20a2... From what i have research i need everything lol: Engine Box Loom Shafts Rad All Ancilleries I have a very strong b18c full conversion im willing to swap with some cash way, if thats any better for the...

I know its an ek9 forum, but its worth a try, does anyona have one? Jdm one aswell without the gay foglight hole :) Preferably in black... Tom

Hi all, Need a b18c4 bottom end for a project i am starting... Tom

Hi all, Looking to build so need a b20 block, i am planning new rods and pistons so dont need them, just need the block and crank... Would prefer good condition, will buy a full engine but i would prefer not too... Tom