Search results


  1. VTEC-334

    Milano Red EK4

    Well haven't posted in a while so thought I'll throw a couple of pictures up to say hi again. :nice:
  2. VTEC-334

    EK9 OEM Silencer & Radio Blanking Plate

    As Above. Cheers :nice:
  3. VTEC-334

    Power Steering Pump

    As above for a EK. Cheers.
  4. VTEC-334

    EK Door Cards

    As above. Need to be for a three door EK with electric windows, Would prefer EK9 one's but would be happy with retrimmed one's as well.
  5. VTEC-334

    Tapered Wheel Nuts

    Looking for tapered wheel nuts to fit my after market wheels. Need 20 and would rather boring old steel nuts rather then the flashy alloy one's. Cheers :nice:
  6. VTEC-334

    EK Rear Light Seal

    As above, For the passanger side. Cheers :nice:
  7. VTEC-334

    Power Steering Problem

    Alright guys need your help again. Topped the system up with Honda PSF-S, Started the engine (Finally :dance:) touch the steering wheel lightly and it spun violently round to full lock where it just kept bouncing off and on lock. Killed the engine turned it manually and it was fine...
  8. VTEC-334

    EP3, DC5, AP1 or AP2 (04-05) Steering Wheel

    As above, Must include airbag and be single stage (Only has one Yellow plug on the back) Cheers :nice:
  9. VTEC-334

    Headlight Rubber Bung

    The big rubber washer that goes in the back of the main beam hole in the back of the case, Managed to miss place one of mine. Cheers.
  10. VTEC-334

    DC2 Intake Pipe

    As above cheers.
  11. VTEC-334

    Air Filter & 3" Velocity Stack

    As above cheers.
  12. VTEC-334

    2.5" EK9 B-Pipe and JDM length Catalytic Converter

    Just wanted to see what people have before I go down the route of making my own. Only want the b-pipe, must be 2.5", must be JDM length and would like it to have a mid silencer so I an get on track. Also need a JDM length catalytic converter just for MOT's. Cheers Again.
  13. VTEC-334

    EK9 B-pipe Length

    Hi Guys, Sorry it's a mundane question but couldn't find anything in the search. Just wanted to know the length of the EK9 b-pips from the Cat flange to the back box flange, the cat flange to the 90degree bend just before the fuel tank and the length of the standard mid silencer. Cheers :nice:
  14. VTEC-334

    Oil Dipstick

    As above, Stupidly misplaced mine when I took the engine out :angry2:
  15. VTEC-334

    CW EK9 Pre-face on the A31 near Ringwood

    Was on a R reg and looked standard. Heading towards Southampton on the A31 when I past you just outside Ringwood at 12:30 Ish
  16. VTEC-334

    UKDM Integra Type R

    Hi Guys This is for my dad :woot: Must be a UKDM (year doesn't matter to much), must be Championship white and preferably standard but I'm sure a few tasteful mods won't be to bad. Mileage isn't a major issue as long as its been look after (service history or a enthusiast) Slight bodywork...
  17. VTEC-334

    B Series Clutch Slave Cylinder

    As Above, must be in good working condition. Cheers.
  18. VTEC-334

    Nice Little Article By Evo Mag

    Just read this (I know it's about a DC2 but I like to think it would be the same for the 9 maybe at push ek4's and eg6's) a thought I share. http://www.evo.co.uk/carreviews/cargrouptests/287455/toyota_gt86_vs_renault_clio_cup_honda_integra_typer_and_bmw_m3.html Not a very long or brilliant...
  19. VTEC-334

    Brand New Discs's and Pads

    As above, Must be new. Looking for either plain or grooved disc's. x2 Front (282mm-4x100pcd) x2 Rear (262mm-4x100pcd) Front Ferodo DS2500 pads (Honda Legend fittment, Think all 282 pads are the same though) Rear Ferodo DS2500 (MGZR 160 fittment, Think their the same as honda 262 pads)...
  20. VTEC-334

    Dc2 Rear seats

    As above, Must be good condition and need to be UK spec ( Think there the only ones that fit in EK's) If anyone has any already mounted to EK foam that would be great. Cheers :nice:
Back
Top