Search results

Can anyone point me in the direction of a boss kit that will fit a dc2 with airbag, either new or used i want a momo aftermarket wheel but need a boss kit to go with it cheers

Hi dudes im looking for the following if possible Passenger rear tail light in good condition no cracks etc drivers side under steering column, either the whole panel, the coin tray and bracket to hold it on or just the bracket itself bling oil cap inlet manifold and throttle body gaskets...

As above dudes some low life tried to Nick the car last night so I need a new drivers door handle preferably In vogue silver but I know that's a hard colour to get but worth a try Thanks

As above guys, I have a stainless 2.5" on it just now but it's too loud for me, it has a replica spoon backbox welded onto the rear, would consider a straight swap for this if need be as it will be surplus to requirements anyway Cheers

In the drivers door at the catch side the window rail for some reason has had the rubber removed so when it's down the window rattles against the rail, so I'm also after the rail and runner if need be to rectify this fault. Please no cheap ebay rubbish looking for something like hardrace or...

above please guys, no cheap rubbish it to fit between the stock 98 spec mani and centre so standard size decat. Silenced would be ideal Cheers

Can anyone shed any light on any benefits of fitting an s2000 clutch master?

looking for a set of the above, will be selling my 16" rota grids also and maybe the 15" teg wheels i have aswell, let me know what you have. must be these wheels not after anything else thanks

Hi guys looking for an intake for my dc2 I can't buy one in itr club because of daft 100 post rules but the forum is so dead ill never gather the posts, anyway long arm of short arm, what have you got? Cheers

as the itr dc2 forum is always dead can anyone tell me if the energy suspension bush kits are any good? thanks

Hi guys just a quick question, I have a set of 16" grids that I want to sell but I don't know how much there worth, couple of marks nothing serious 4x toyo proxes they have signs of weathering but decent tread they are ek9/dc2 fitment which you'll know 5x114.3?please correct if I'm wrong. Cheers

I m sure iv seen a thread on here about turning a pas rack to non pas? Can anyone shed some light on how to do this? Thanks

Does anyone have any of the above? Mine was stolen along with a seat rail for my mg. don't ask me how :( money is tight enough just now Thanks

on the main harness please dudes. :) sorry obd2a harness

hi guys im looking for an ek/teg coolant bottle holder and also the power steering bottle holder in as good nick as possible pm me prices delivered to EH329SF please :)

Hi guys looking for the above must be a straight unit not the one like mine with the a bend in the shifter Pm me details please thanks Also I'm located in Edinburgh

are the wiring looms to and from the ecu 's exactly the same ie wiring colours and pin outs? as i cannot find a wiring diagram anywhere for a dc2 but plenty for eg's and ek's? thanks

as above please, looking for an ecu for my b18 zr setup so i can wire it all up thanks

am i right in saying is a plug and play swap from a ukdm ecu and also does not have an immobilizer chip? thanks

Hi dudes just wondering what sort of money is in these as im thinking about parting with mine to get some cash in the bank thanks