Type R stickers look smart , Got them on my Eg6 with a B18c in it. That did start life as a DX , This is not a DX as has black side mouldings , a DX has none ( super light weight )
I run a Quaife Gear kit with ratios
1st 2.462
2nd 1.813
3rd 1.500
4th 1.250
5th 1.045
And a 4.750 Final drive
Car has a JDM 96spec B18c with a light weight flywheel and 4,2,1 manifold.
Would a Mfactory 4.925 work with this gearkit ? Car is a Rally EG6
Want to improve accleration ...
Removed from a 98 jdm engine , Type R intake manifold . £85 ono
Also complete B16a cyilinder head £125 ono .
Both used condition , location south west england . But will post
That great info already , the info and advice on this forum is the best i have found
thanks guys . Dont suspose you got the sizes of the sumps for a b16a and b18c
Is a B16b sump not as deep as a B18c one , wondering how much lower to the ground i am going to be when i do my B18c engine swap . Any info thanks in advance
Integra type R intake manifold £85
B16 Engine removed from a ek4 vti 67000 miles £350 ono
B16 cylinder head complete £125ono
contact Dan 07884498337
Ok guys looking for some advice . i am fitting a integra type r intake manifold to a b16a engine , what do i do with the fuel rail , the standard b16 has rubber bushes between the rail and manifold , but if i use these on the type r intake i can not fit a nut on the thread. ?
And i have a...
As tital says will a Y21 Gearbox bolt up to a B18 Block .
Thinking of going B18c in my civic EG6 vti rally car , but want to use my exsisting box (y21).