Search results

Hey lads I know this topic has been covered many times over but Im completely lost, basically was driving my ek civic (b18c) and it just stopped dead on my way home, pulled at the side of the road and it started up right away again got back home and cut out again, this time it will not start...

Hey lads once again im having ignition issues, long story short i replaced my engine loom (obd2b) on my b18c ej9, since swapping i noticed my engine light aswell as oil light will not come on when ignition is switched on, usually the engine light goes off after about 3 seconds roughly, ive full...

Hey lads just on the lookout for a few bits :Obd2b to obd2a conversion harness :Ek4 sir clocks :carbon slug intake (whale *****) Located in ireland so must be willing to ship Thanks

Hey lads, so ive just done a b18cr swap on my civic, the p/s belt never came with the engine so ive nothing to compare with, every belt i get is too short, twice i got a belt from my local motorfactors and one from japserviceparts, anyone know the belt number that ill need to get? Thanks in advance

Alright lads i know this is been done too many times to be fair but i cant find the info that i need, so basically i have a 2000 ej9 1.4, ive swapped a b18c from a 98 spec dc2 and 4.4 lsd s80 box, my only question is that my own 1.4 dash loom has a plug that cannot plug into my p73 ecu because...

Just a few pics of my kanjo styled ek, currently undergoing surgery (b18c r) :fapfap::ek9:

Right lads, here is my civic ek with a b18c swap going on at the moment, currently just tightening up a few loose ends and should be up and running in the next few days :nice:

Hey lads, ive been following this forum for a good while and decided to finally bite the bullet and sign up

Hello lads, ive been following this forum for a good while now and decided to sing up, im in a bit of bother with my alternator on my b18c, basically i have a b18c from a 98 spec dc2 which as far as i know is obd2a, correct ne if im wrong, i also have an engine loom from a ek4 vti pre facelift...