Advice/help needed!! K24/k20 swap


rob333

Member
Joined
Jul 12, 2008
Messages
80
Ok so I have a k24/k20 swapped ek9 car has been build since December been using it on and off when I can as is really a track car, yesterday I took it to get some new tyres for japfest as I had track time booked on my way home the engine check light came on and the car started to splutter and eventually died, couldn't get it to start again so towed it home, now it will not start with a little throttle but splutters with a Rev and dies when you come off the throttle,
Iv changed map sensor, checked all earths, cleaned iacv sensor, changed sparks, cleaned fuel filter, checked injectors, no error codes come up on the kpro when check light comes on?? I'm all out of ideas any one help?
 
After you've done all of that my guess would be TPS. Notoriously poor on k20's. If you go into kmanager and data log you'll be able to check the Tps values live.
 
Check your camshaft cam gear bolt. The single 14mm bolt. If it wasnt tightened properly, it could have snapped the camshaft wedge key.
 
Back
Top