Brake Refurb (Slider pins)


Glenn1

New Member
Joined
Dec 17, 2013
Messages
21
Hey guys,

looking to replace my slider pins as they are rusted solid. Im wondering does anybody know where is the best place to get the rubber boots grease and the slider pins from? Should you only use OEM or what are peoples thoughts. Honda are looking for a scary amount to do all four corners.....:yuno:
 
Brake parts.co.uk will have everything

Used them a few times , no issues. Way cheaper then Honda.

Jap service parts do the seal kits too but not the slider pins
 
brakes internation / brake parts.com. used both, just make sure you get the right parts before you start. need to clean out the hole for the slider pin on the carrier too or its just a waste of time.
 
Thanks guys, How would I go about cleaning out the holes? The pins are all rust so I assume the holes are the same.
 
Get a drill bit the same size as the hole think it's 10mm and just twist it with your fingers in and out should draw all the gunk out
 
Back
Top