Headers DYNO Results !! On stock Integra Type R engine.


SpoonCTR said:
i read that the one you got are toda copy? :shocked: can you post a picture? :nice:

no problem, here are some pics. mine is a 2 piece, the newer ones are 1 piece.

stock photo
Edelbrock_Pro_Flo_Header.jpg


the one on my car
gh3.jpg

gh2.jpg

gh1.jpg


what it looks like off the car. this one is for a b18c1.
h10.jpg
 
SpoonCTR said:
nice header, what brand is it? did you have problems installing it? specially the 02 sensor? :nice:

not problem with the sensor i'll show you a pic later,i got it from the europe omnipower dealer www.xmotorsport.net ,you can find it know with 3-4 brand names now with few diferences.
 
No_Fear said:
not problem with the sensor i'll show you a pic later,i got it from the europe omnipower dealer www.xmotorsport.net ,you can find it know with 3-4 brand names now with few diferences.

Nice header! i haven't seen it in a USA dealer, you have a b16b right? :thanks: for the pictures
 
No_Fear said:
Nice header! it has a 2.5" collector right? :nice: Where did you bought it? i dont see it in omnipowerusa.com site
 
np,have in mind its not a mass production header, so it will delay little bit.
 
So what header was used on the STOCK ITR motor? I thought they were all 4-1?

Stock 176 / 119

JDM ITR 4-1 185 / 137
 
dut said:
So what header was used on the STOCK ITR motor? I thought they were all 4-1?

Stock 176 / 119

JDM ITR 4-1 185 / 137

ITR 4-1 2.5" OUTLET, TUBULAR
CTR 4-2-1 2.5" OUTLET, CAST
 
Back
Top