Integra Type R Trailing arm question.


Splatv6

New Member
Joined
May 17, 2016
Messages
12
Likes
2
#1
Sitting here trying to figure a way to make this short and sweet.....

What is the difference between, the Rear ITR trailing arm, and lets say a GSR, or SIR?

Because.... all these arms come without the hub and bearing, and they all look the same!?!

See, I bought a BNIB ITR USDM Right rear trailing arm, years ago.... now that I started to pick up my project again, I see that the Left rear trailing arm has been discounted. Part Number 52371-ST7-R02

Any help?
 


Splatv6

New Member
Joined
May 17, 2016
Messages
12
Likes
2
#2
Ok..... with a ton of reading over the night, I'v learned that the ITR and CTR rear trailing arm are the same.

But, what make's these arms different from, lets say a Integra or Civic with rear disk, is the bushing and spindle.

Now, from what I'v read, Japan sells the rear spindle that is attached to the trailing arm, and is what the Hub/bearing is pressed onto separate.

Would any one know the part number to the ITR or CTR spindle part number?

Here in the US, its sold as 1 one unit, and the left arm has been discontinued.
 


SPek9

Donator
Donator
Joined
Aug 24, 2009
Messages
2,501
Likes
216
#3
As far as I’m aware the DC2 and EK9 has strengthened rear trailing arms.. you can see extra steel spot welded into the inside of the arms that non-Type-R arms to not have
 


Splatv6

New Member
Joined
May 17, 2016
Messages
12
Likes
2
#4
Anyone know the left rear spindle part number, or the Japan part number for the left rear trailing arm?
 



Top