Ive just had my engine built,
Running a b18c bottom end with ek9 pistons, im running skunk2 pro2 cams
Just wanted to know if anybody else has run this setup before and what the piston to valve clearance was like, before i do anything i am going to clay the engine but just to be on the safe side i wanted to know if anybody else has had problems with this set-up
any feedback will be much appriciated
Adam
Running a b18c bottom end with ek9 pistons, im running skunk2 pro2 cams
Just wanted to know if anybody else has run this setup before and what the piston to valve clearance was like, before i do anything i am going to clay the engine but just to be on the safe side i wanted to know if anybody else has had problems with this set-up
any feedback will be much appriciated
Adam