Skunk2 pro cams into b16

[eg2_portuga]

Hi guys, just wandering what cr numbers we need to run some skunk2 pro2+ and pro3+ on a b16a??? Iknow that they're too large for a stock b16, but if we have some 11.7:1 cr wiseco forged pistons can we extrat the most from the pro2 or even the pro3??? Now I'm just on doubt but when the time comes it'll be better to spend the Money on the right camshaft and don't go too big or too small lol
Thanks for your opinions\toughts

 

[Eoghain]

Pro 2's with supporting valve train is more than enough for any b16, pro 3's are only really for a 2 litre. I would suggest fitting a set of up rated rods too and bring the rev limiter up to 9000rpm, you will have a torquey and powerful package then

 

[eg2_portuga]

Maybe I read it wrong, but I was thinking that the pro2 can make power till 9400rpm or something closer to that....didn't think about the rods, eagle rods should be fine????

 

[Eoghain]

yup eagle rods are more than fine