I am about to start running new brake lines on my 9
I am removing ABS and will be running a bias valve
So the plan is to run the lines through the inside of the car
I am a bit confused on what port to use from the servo for the front/rear brakes
Looking at other peoples pictures, it seems both can be used ?
But i can remember reading some where that one gives out slightly more pressure so is best suited for the front brakes but i cannot remember what one or find the thread.
I think it was the rear (furthest from engine) port to be used for the fronts, but not sure
Can anyone help on this ??
I am removing ABS and will be running a bias valve
So the plan is to run the lines through the inside of the car
I am a bit confused on what port to use from the servo for the front/rear brakes
Looking at other peoples pictures, it seems both can be used ?
But i can remember reading some where that one gives out slightly more pressure so is best suited for the front brakes but i cannot remember what one or find the thread.
I think it was the rear (furthest from engine) port to be used for the fronts, but not sure
Can anyone help on this ??
Last edited: