Recent content by Cutz

Gents, I'm building a suspension dynamics calculator / spreadsheet, it's 99% finished and I'm looking to finalize a few EK9 suspension weight and angle measurements before I can consider it finished. I don't fancy stripping the car down to weigh parts so I'm hoping someone's already done it...

just bought a set of brand new EK9 visors from this chap... just excellent and delivered quickly!

pm sent about the mirrors

hey matt, have sent you a PM on civiclife about the mirrors... drop me a message back and i'll get payment arranged!

100bhp

damnit. could have really done with this lot :-(

got one available for me? drop me a PM if you do ;-)

Just out of interest; Are there any marks / differences that identify these prop valves vs the standard one ive got in my rear drummed EJ9? Thanks Matt

pm sent regarding the Hondata S300 ;-)

I have a similar issue on my EJ9 mate, my brake prop valve looks the same as yours yet I had no rear discs until i converted. apparantly the one you need if off an early integra non-abs all-disc. i get the feeling they'll all look the same...no-one has confirmed if there's a stamped...

damn that looks tidy

i hung mine for quite awhile to get them nice and straight again then polished the **** out of them with some proper plastic polish...sent them back to new ;-)

you shouldn't have any problems mate, easiest thing to do is pull the wire from the ecu multiplug, try it and check voltage. if it's what you want and no CEL codes then leave it out, if not put it back ;-)

my mum needs an integra in her life too!

if you cut the ALTC wire that should stop the alternator dropping into 12v mode.