Recent content by eg9Paul

No power figures yet. Mapping in the next few weeks... Just have it running a base map on the hondata. But have a wideband to keep an eye on the afr

Cheers man, was a lot of work and it's not quite over yet but its getting there

Always been a big fan of the eg9s, it was the first vtec civic I ever had a spin in so they always seemed special to me. Yeah it has ek9 hubs and brakes, some difference over the std vti brakes especially with the braided lines

Hey just thought i'd share my eg9 build with yous. All the work except paint was done by myself and friend of mine The Original Car: The I got the eg9 shell from a mate who had left the car to rot in a field, after an unfortunate incident with a hedge. The Good: * Full and pretty clean...

Sweet man that's the job thanks

Hi, Need to zero my B18 Type R cams after getting head/block decked can anyone shed some light on the Honda specs for the degrees BTDC /ATDC where the center line/max lift of the cams should be I've been through the honda service manual and found nothing, the thing is massive tho so might have...

I never specified I will be going with the Tuner series cams if that makes a difference. I would have thought that a good tuner could adjust the cam timing to to find the sweet spot relatively easily so long as there is sufficient piston/valve clearance? I'll be honest, I haven't boosted a...

Yeah I'll be going with skunk2 stage 2 cams and valve train, port and polish and get a 3 angle valve job done. In the future (if it's less of a daily) I might throw a bit of low boost at it with a td05 but be keeping it decently high compression, see how it takes to that, ha! That's a good...

Yeah that's where I'm at too. Think I will just just get a b18 piston put on a rod to try it out and go from there. I'm sure the machine shop will be able to spec the Pistons if not Cheers for the reply anyway!

These are pretty much the best specs I can get on the crank(posted below) - the stroke is 84.709mm I looked up the part number for the rods just don't have it handy to double check at the time and it came back as just the standard length rods The kit normally comes with JE forged pistons when...

Hi, I have bought a used Eagle Stroker kit for my b16a2, I got it pretty cheap with the Forged Crank, Rods and new Acl race bearings. The kit is just missing pistons and I have no clue of the pistons specs I need to get made as I don't think the kit works with standard pistons (rods are standard...

Very clean car, a friend has a championship white 00 ViRS real nice cars

Go bigger again 3inch is what you need, so that you don't have any back pressure, back pressure is the devil

Top quality photos