Recent content by Peebs988

Can you email me on nomis988@hotmail.com very interested mate

Are these wheels also 4x100?

Do you still have this? Will you sell the speed sender?

Can I use the b16a eg9 loom on a b18c4 engine? Or should I use the mb6 loom? Cheers

Does anyone rate hard race camber components? Need to sort the camber on my eg but don't really wanna pay skunk2/buddy club prices Thanks

I'm interested in the b18c4 can you email me nomis988@hotmail.com Thanks

I have a recaro on ek rails but iv just bought a eg will the seat fit the eg rails?

Can I put a b16 head on a b18c4 bottom end the head has ek9 cams in, will this be ok with the standard pistons or will the valve touch? Also it will be going into to my ek4 can I use that loom with this setup? And just use a p28 ecu?

No worries dude should of stated the setup properly, sound peeps

Itr disk, I have done the hub conversion but used prelude calipers. I'll try the washers for now sound mate

i thought so which part has to be shaved? is it where they mount to the hub or where the carrier touches the disc?

I have used the 282mm calipers off the 2.2 prelude it seems the carrier is rubbing against the disc, have i fitted them wrong or do they need modifing? cheers

So now I'm in 2 minds lol

Nice one for that Jimbo and i'll take a look.

Can the baddy club extended ball joint be used with the buddy club upper camber arms? Or do you use one or the other? I already have the camber arms and need new lower ball joints so i dont wanna buy them if its pointless cheers