Search results

is this over the top with the asr brace and the beaks brace?if you had one would you need the other? im looking to use the car for track use in the future, so im doing the chassis to start. cheers

i was offered a b16a1 block and head for really cheap so i took it, and i did some looking around and was just wanting some1 to check what i think i have found for my swap? A-i can use my d series alternator with different mounts and a different sized belt? B- i can use the s/p from my d series...

my shell has fairly had it and am loking for a shell with bair min work to do to it??

i was wondering if i can use these parts from a d series for a b series? from sense, i would assume that tha dizzy and starter motor would be different but i thought the powering steering pump, and altenator would be ok to use?am i correct?

Not to sure if this is in the right place and apologise if it is but: i have had a look around and cant quite find what im looking for, does any1 in the north east scotland no of any places that do hot tank dipping?(if thats what its called)Looking at getting my block and head done befor i...

im doing a wire tuck and cant fiqure out where 1 wire goes. iv looked through my diagrams and can't find it. Its a blue/red wire with a 1 pin brown connector on the end. It comes out the opposite side from the fuse box and battery in the grey plug for the light loom and runs to just behined the...

Hi im doind a shave and was wondering if any1 Can tell me what has hapened to his power steering pump and reservoir? Iv manage to move everything else thats requied but cant see where these items have gone. any help would be much appreciated:bow:

What is the harness covered in? And for a rhd(dont no if it would make a difference in the wire harness) civic the harness would start on the right side(looking into the e-bay)and works its way across to the end of the gearbox? Would be much appreciated:nice:

would some1 with an x brace mind posting or taking some pics of all the joints in the drsign. My bro is a fully coded welder and was thinking he could make 1.

Wasnt sure where to stick this but i was wondering where things in your engine bay can be relocated to? Like battery, fuse box, etc? Is it possible to move your powering steering pump as i have seen many pics where i cant it.

Does any1 no where i could find an armrest center console for an ek? Can you take it off any other models?

hi, im kinda newbie to engines but im giving it a shot as i want to learn. im rebuilding my d16y8 and noticed some wear on only 1 side of the piston and its on the same side of each piston.(when i say wear, i mean slight scuff sorta marks) I checked and had my bro look just incase i didnt see it...

hi guys, can any1 give me some good cheap ways of cleaning an engine? i no good and cheap dont normally go together but i have very limited funds .

doing a bit of a project as was wondering if any1 nos any techniques for doing this, if possible? p.s my bro is a pretty good fabricator so should manage a fair task befor having a garage involved.

i recently bot a set of adjustible coilovers, just a cheapy off ebay as im a student and will get better as i find a job . but to the matter at hand, when i put them on the car, the camber arm was at a very steap angle, alot more than normal. The only other thing to take into account was that...

see when your doing the ek9 light job, do you have to you high temp. paint?

Hi can any1 tell me how you remove the orange lense in the back left light so it is clear on a ek hatchback? http://www.ek9.org/forum/attachments/interior-exterior/7345d1249015930-how-make-rear-lights-like-ek9-honda_ek9_03_noviembre_2006-054.jpg Like this one. instead of...

hi there, io was wondering if some1 with a d series engine would mind taking/posting up some pictures of there engine bay with as much in as possible e.g. mounts, backwall mountings, as i have had my engine out for a bit and have kinda confused myself with the locations of certain things.

is it true that useing the steering rack off of a bigger engined car makes it heavier? for example : if i had a 1.4ej9 and i used the steering rack off of a 1.6 coupe.

hi iv got an ej9 and i was wondering what car/cars i can use the rear trailing arms off of for a rear disk conversion?