Search results

Can I use the b16a eg9 loom on a b18c4 engine? Or should I use the mb6 loom? Cheers

Does anyone rate hard race camber components? Need to sort the camber on my eg but don't really wanna pay skunk2/buddy club prices Thanks

I have a recaro on ek rails but iv just bought a eg will the seat fit the eg rails?

Can I put a b16 head on a b18c4 bottom end the head has ek9 cams in, will this be ok with the standard pistons or will the valve touch? Also it will be going into to my ek4 can I use that loom with this setup? And just use a p28 ecu?

I have used the 282mm calipers off the 2.2 prelude it seems the carrier is rubbing against the disc, have i fitted them wrong or do they need modifing? cheers

Can the baddy club extended ball joint be used with the buddy club upper camber arms? Or do you use one or the other? I already have the camber arms and need new lower ball joints so i dont wanna buy them if its pointless cheers

I have had but b16a2 head port and polished im going to be fitting ek9 cams, im about to buy supertec double valve springs what i need to know is can i use my standard retainers with them without any problems? any help will be sound.

I have done the integra type r 5 stud conversion but i am yet to buy rear cailpers just wondered if the ep3 calipers will fit on the 98 spec itr rear hubs? A friend has some so just seeing if i can money save at all really. cheers

Hi i'm after some advise. Basically im rebuilding b16a2 engine with these parts b16a2 head port and polished with valves cut at 3 angles ek9 cams nippon high compression b16b pistons king race bearings for b16a2 nippon gasket set I have now found a cheap b18c4 bottom end so i have a...