Hi i'm after some advise. Basically im rebuilding b16a2 engine with these parts
b16a2 head port and polished with valves cut at 3 angles
ek9 cams
nippon high compression b16b pistons
king race bearings for b16a2
nippon gasket set
I have now found a cheap b18c4 bottom end so i have a few questions...
will the b16a2 bearing i have already bought fit the b18c4 engine?
will the rods need shaving down 1mm each side as the pr3 rod do to fit b16b pistons?
will the b16a2 loom work ok with this setup?
what ecu to use?
I know it will need a map to get it running properly but will it run of a standard map? just say dc2 ek9?
any known problems or difficulties with building and running this set up?
any help is appreciated
thanks
b16a2 head port and polished with valves cut at 3 angles
ek9 cams
nippon high compression b16b pistons
king race bearings for b16a2
nippon gasket set
I have now found a cheap b18c4 bottom end so i have a few questions...
will the b16a2 bearing i have already bought fit the b18c4 engine?
will the rods need shaving down 1mm each side as the pr3 rod do to fit b16b pistons?
will the b16a2 loom work ok with this setup?
what ecu to use?
I know it will need a map to get it running properly but will it run of a standard map? just say dc2 ek9?
any known problems or difficulties with building and running this set up?
any help is appreciated
thanks