StealthIsKing
Member
- Joined
- Jan 16, 2014
- Messages
- 33
My EJ6 Turbo Build
Introduction:
Goal:
My power goal is 350WHP, and hopefully be able to get a good power curve with some head work.
Build Parts:
Introduction:
I got the car from shell in 2014 and slowly built it up, I put a D14A4 into it due to insurance limitations.
I was set on getting that 'stance look' due to the fact my car would have near to no power.
Now that I'm able to change up an engine, I've decided to do a turbo build.
I was set on getting that 'stance look' due to the fact my car would have near to no power.
Now that I'm able to change up an engine, I've decided to do a turbo build.
Goal:
My power goal is 350WHP, and hopefully be able to get a good power curve with some head work.
Build Parts:
Engine
- D16y7 - Received
- 75.5mm Vitara Pistons - Received
- NRP Pistons rings - Received
- Felpro Head Gasket - Undecided
- ACL race bearings for crank and rods - Not yet purchased
- New oil and water pump - Not yet purchased
- P2P0 Custom Length Rods - Not yet purchased
Drive train parts:
- Excedy (or similar) Stage 2 Clutch - Not yet purchased
- s20 Gearbox (Big bearing Version) - Received
Management & Fuel
- P28 Neptune Chipped ECU - Not yet purchased
PTW Clearance 0.003 (Imperial Measuremeant)
Arrows on pistons towards flywheel
Do not forget dowels for headgasket - 2 of them
Arrows on pistons towards flywheel
Do not forget dowels for headgasket - 2 of them
Last edited: