Recently bought this with the intention of using the B pipe and decat for my system but due to my manifold being retarded it wont fit (bolt holes on the collector sit further out than the ones on the decat flange) and now i need some money back from it as it sent me into my overdraft 
(
Condition wise the centre box has some scraping on it but no dents and the rest of the B pipe is fine with no dents on it. The backbox also has some scrapes on it, theres a dent on the bend just before the actual box where its obviously taken a hit due to it being an under LCA system. Also the baffles are pretty worn and could do with being repacked or just blown out and see what it sounds like. If you look down it all you can see is the wire wool and if you bang it on the ground bits of tiny bits of baffle come out but not huge chunks.
Obviously the box is stainless but the rest of the system isnt and isnt in that bad condition apart from the scrapage along the centre box.
Its a 60mm system, as is the decat but we measured the collector end of the decat and its just about 2.5" on the very end of the pipe so with any luck should fit a 2.5 manifold. Bit of a pain as when i bought it it was listed as a 2.5" nevermind.
I`ll get pics up at lunch time as i wanted to get the add up now while i had a free 10 minutes at work.
Im looking for about £180 for the lot and i will be at Japshow so if anyones going and interested it can be collected from there. If not im located in Milton Keynes.
(Condition wise the centre box has some scraping on it but no dents and the rest of the B pipe is fine with no dents on it. The backbox also has some scrapes on it, theres a dent on the bend just before the actual box where its obviously taken a hit due to it being an under LCA system. Also the baffles are pretty worn and could do with being repacked or just blown out and see what it sounds like. If you look down it all you can see is the wire wool and if you bang it on the ground bits of tiny bits of baffle come out but not huge chunks.
Obviously the box is stainless but the rest of the system isnt and isnt in that bad condition apart from the scrapage along the centre box.
Its a 60mm system, as is the decat but we measured the collector end of the decat and its just about 2.5" on the very end of the pipe so with any luck should fit a 2.5 manifold. Bit of a pain as when i bought it it was listed as a 2.5" nevermind.
I`ll get pics up at lunch time as i wanted to get the add up now while i had a free 10 minutes at work.
Im looking for about £180 for the lot and i will be at Japshow so if anyones going and interested it can be collected from there. If not im located in Milton Keynes.
