EJ6 5 Lug Conversion

[Bucc-i]

does anyone know what i need to do a 5 lug conversion for my EJ6. i can't find the parts or instructions anywhere? any one...plz... HELP!

 

[blinx9900]

new wheels 5x114.3
new rotors 5x114.3 off an itr
new calipers off an itr
front+rear hubs/spindles off an itr

 

[rvm]

new wheels 5x114.3
new rotors 5x114.3 off an itr
new calipers off an itr
front+rear hubs/spindles off an itr

Hmmm, I think the prelude vtec calipers will do the job, they're the same right? correct me if I'm wrong blinx

 

[blinx9900]

Hmmm, I think the prelude vtec calipers will do the job, they're the same right? correct me if I'm wrong blinx

you are correct, prelude vtec uses the same rotor, i dont remember what yera though. i would just go with itr to keep it simple, that way you always know your entire brake system is itr and sourcing parts will be simple

 

[Bucc-i]

what about S2000, are they compatible?

 

[vtecroadhog]

Hmmm, I think the prelude vtec calipers will do the job, they're the same right? correct me if I'm wrong blinx

the prelude comes with 4x114.3 not 5... as i was thinking on replacing these on my ek4 for bigger brakes and to fit a set of rims which came with incorrect hole fitments (mugen m7's )..!

 

[blinx9900]

the prelude comes with 4x114.3 not 5... as i was thinking on replacing these on my ek4 for bigger brakes and to fit a set of rims which came with incorrect hole fitments (mugen m7's )..!

i though one of the last 2 generations were 5 lug? i could be wrong, not huge into preludes... i do know that you can use prelude rotors (redrilled to 4x100) with itr/ctr calipers on an ej6

 

[diyek9]

the prelude is a 5 lug 97+ i believe. but will the spindles fit with with the lines? if so im gunna do it. i seen preludes with itr wheels also?

 

[blinx9900]

the prelude is a 5 lug 97+ i believe. but will the spindles fit with with the lines? if so im gunna do it. i seen preludes with itr wheels also?

i highly doubt you can use the spindles off a prelude, i was only saying perhaps the rotors could be used.

 

[jugbugz]

Bucc-i PM sent.

 

[Bucc-i]

Bucc-i PM sent.

Got it! Much Luv!

No one answer my other question though! is the S2000 parts compatible with a EJ6 or EK9?

 

[jugbugz]

Got it! Much Luv!

No one answer my other question though! is the S2000 parts compatible with a EJ6 or EK9?

no way, it's rear wheel drive for starters.
PM sent. Just find out if your axles are same as CTR or ITR.

 

[Bucc-i]

no way, it's rear wheel drive for starters.
PM sent. Just find out if your axles are same as CTR or ITR.

BLINX! do you know if the EJ6 driveshafts are the same as the CTR? ie knuckles, hubs, etc...
If not could i put in an ITR driveshaft with no problem?