!!HELP!! Rear subframe brace


fljoshua129

fljoshua129

NON-VTAK
Donator
Joined
Aug 28, 2010
Messages
1,299
I replaced the oem rear subframe brace on my ek9 and two of the bolts snapped. Im getting them drilled out but don't know where to get new bolts. Anyone know a part number for these? Or if anywhere sells them?

Cheers
 
I got stainless lca nuts and bolts from a guy with the username bolts bolts. Not 100 % sure if he does the subframe ones though.
 
Rear-Beam.gif


Position Description Part Number Quantity
1 BEAM, RR. 50200-S03-J00 1
2 STIFFENER, RR. BEAM 50210-S04-000 1
3 BOLT, FLANGE, 14X100 90161-S04-000 4
4 BOLT, FLANGE, 14X83 90162-S04-000 4
5 BOLT, FLANGE, 10X16 95701-10016-08 4
6 ROD, RR. LOWER ARM PERFORMANCE 74350-S03-Z00 1
7 ROD, RR. FRAME END PERFORMANCE 74370-S03-Z00ZZ 1
8 BOLT-WASHER, 8X16 93407-08016-08 4
9 BOLT, FLANGE, 12X20 95701-12020-08 4
 
May find you'll need a different size from the standard ones depending on the size of drill bit you use. Not too clued up on whether theryre just a through hole or tapped? If theyre tapped then I'd guess they'll have to be re-tapped a different size
 
I have one of these rear reinforcement bars to fit in an EK4 hatch, are they bolted in from underneath up into the boot floor/chassis, or are they bolted from inside of the boot floor to the outside?

Would the hole on the chassis/boot floor threaded already if its not an EK9?

Thanks
 
If you are talking about the original ek9 bar its bolted underneath, the subframe on ek9 is different to other EK models iirc so it might not fit
 
You must log in or register to reply here.
Back
Top