holy f#%! more leaks...

[randeg6]

so i did my 3rd rebuild.
painted car.
new turbonetics turbo.
and went to a sandwich plate this time. i have thread taped tightened down all the lines and the filter.
i had a leak. so i took off the ****. i cleaned up everything and then i tightened it down again. now its still leaking but i pulled off the piece that holds on my sandwich plate and it pulled out the oil filter stud. wtf?!?!?!
then i put everything back together a third time and it is still ****ing leaking. about a drop every seven secconds
idk wtf to do guys.



anyone else had this problem?
anyone have any advice?

 

[blinx9900]

What brand sandwich plate are you using? Did it come with O-rings?

I use a Greddy sandwich plate which has 2 O-rings, it was a bit of a pain to install it properly and make sure the O-rings stayed in place.

 

[randeg6]

only one oring.
but the thread pitch for the feed lines were in brittish tapered pipe thread.
so i think its the wrong sandwich plate. gonna take it off and clean it one more time.
(