is this the right one for my B16A2


Well according to the ad, no it isn't. It says it's for a B18C1 or any B-Series with a B18C1 head. I think it would fit but I'm bettin this intake was optimized for the C1. I know that ITR manifolds will bolt up to a GSR and the ITR one is pretty similar to the A2 one if I'm not mistaken cause a lot of intakes say they fit B16A2's, B18C5's, and B18C1's with C5 manifolds. Some one correct me if I'm wrong cause I'm no expert.

EDIT - Just looked it up on Skunk2's site. They have 3 B-Series manifolds. One for B18C1's, one for B18A/B (LS motor), and one for B16A/B, B17A, and B18C5 so I'm assuming there are optimization differences or something cause again, I've read that C5 manifolds bolt up to the C1 head.
 
Last edited:
it says its for the B18C head!

Might be compatible with a B16A?!, but im not too sure myself!
 
I think is for a B18 engine but i think it would fit!
I 'm telleing you that will fit because i have many mates that they have fitted on their B16A2 manifold from integra.
 
see if you can get a used B16b manifold or an ITR manifold
 
It will NOT fit. The B18C heads has a different bolt patten to B16A/B/18Cr heads ;)
 
You must log in or register to reply here.
Back
Top