losing patience now!!


gazza

gazza

GAZZA
Joined
Dec 6, 2009
Messages
387
ok i changed all my plugs and changed the dizzy was working good then started its s**t the day again. The first time it hapened with the 1st dizzy it wasnt picking up revs no power and dying on me then strugling to start.This time its just low revs occasionaly no power and sounds like its running on 3 cylinders and then kicks into life again and all normal.So its not cutting out and its just occasionaly doing it now im changing the leads on friday will see how that is but is there any other ideas im needing anything the now starting to lose my temper haha
 
Plug out your 02 sensor next time it happens if leads don't cure it and see if it runs better
 
Its the sensor on the exhaust manifold - you can reach in behind your inlet manifold to find the plug to disconnect it.
 
check ur injectors are workin cause there on the same plug as the dizzy unlug injector turn it over and check the resistance by using a multimeter check each one. if not unplug dizzy and check the 10th pin in the plug connector and turn it over to rule out that and check u coil is sparking right
 
sorry guys forgot about this thread i cleaned all my connections and is running sweet as a nut now thanks so much for your help guys really appreciated
 
What did you sort out, your o2 sensor?
I put new dizzy cap, rotor arm, magnecore ht leads, still sounds like its running on 3 cylinders sometimes around 2-3k rpm

Mat
 
You must log in or register to reply here.
Back
Top