Lowering Spring help?

[Andy_EK]

Hey guys I'm wanting to buy a set of lowering springs but not quite sure on how low to go was wondering if anyone could help?

I seen a set of Tein S. Tech which takes the front down 25mm and rear 15mm as the back of my car is already lower than the front i was thinking these would do the trick but not sure if it will still sit too high, dont want any arch gap at all tbh but if i get 40mm all round i think it'll be too low and the back will just scrape.

Cheers.

 

[RoEk9]

Why and how is the back lower? doesnt seem that way from the photo?

40mm would be just fine loads of 40mm springs around, but if i were you i would buy coilovers and set the ride height to whatever you want!!

 

[Andy_EK]

it doesnt show it in that photo but cause i have all my work stuff in the boot it is lower than standard at the back by about 10mm i'd say, and i cant get coilovers as i wont get insured with them.

 

[kammy11]

Alrite mate I went for 35mm all round on my EJ9, here is a pic hope it helps...

 

[Andy_EK]

cheers mate, made my mind up after seeing that, going for 40mm all round then!

 

[kammy11]

Good choice mate, mines are between 35mm and 40mm so its not goin to be any lower than that. Also you will have no bother with speed bumps etc. As you can still see the rear is still slightly lower but it looks good if you as me