new 9 owner


jock4321

New Member
Joined
May 19, 2010
Messages
45
well after a good stint with a jdm dc2 ive bit the bullet and got an ek9 as ive always been a fan of them.picked her up a few days ago and spend them giving it a good detailing session.im now on the hunt for a new exhaust,im after somthing fairly quiet,any ideas.i also quite like the offset back box.which systems have these.

Picture100-1.jpg

Picture097-1.jpg


oh and heres my wee domo

Picture103-1.jpg
 
seen that car before,guy on here owned it before that right?

go for mugen or apexi ws2 if you want quiet exhaust :secret:

looks clean car....enjoy :drive:
 
ye i believe he was on here,but he part exed the car so i didnt meet him.ive heard the ws2 is quiet but not too sure i like the look.what are peoples opinion on the fujitsubos's
 
beautiful ek9! thanks for sharing :D
 
Nice Facelift :nice: Where did you get your Domo from? I have been looking for one that size for ages :(
 
thanks guys oh and my wee sis made the domo :)) i could always get her to make another one if you want.
 
ye i believe he was on here,but he part exed the car so i didnt meet him.ive heard the ws2 is quiet but not too sure i like the look.what are peoples opinion on the fujitsubos's

Fujitsubo and very good systems, i would say next behind mugen for quality. You will not find a better made/materials than Mugen. Oh Fujitsubo make the OEM Honda exhausts.

By the way i imported your ek9 :nice:.

:welcome:

Dunx
 
cheers lads oh and i knew it was one of yours dunk.another fine example.btw did you install a fog light for the sva when you imported it mate.it doesnt seem to have one now.
 
Fujitsubo RM01A is a very nice sounding exhaust a tad louder then the Mugen Twinloop. Fujitsubo RM01A gets my vote :)
 
cheers lads oh and i knew it was one of yours dunk.another fine example.btw did you install a fog light for the sva when you imported it mate.it doesnt seem to have one now.

The fog wire should be behind the drivers light unit.
Remove both lower side bulb holders, swap fog wire with aftermarket plug next to it, put reverse light into side hole at the bottom.
Now it will look like a fog light and you can swap it back after.
Dunx
 
Back
Top