Skunk2 Pro1 cams on standard b16b??


K

kiwi

Member
Joined
Mar 31, 2009
Messages
231
Whos runing the skunk2 pro1s in their standard b16b? This is a question not relating to valvetrain because thats been done a hundred times but relating to valve to piston clearance. Are deeper valve pockets on the pistons required to run these, as they have 1.1mm more lift on the inlet and more duration.

Cheers
 
I never heard of anyone needing to machine the pistons for clearance when using these cams so I would say you will be fine running them.
 
There weren't any clearance issues for the Stage 2's on the B16b bottom end of ours so I guess there shouldn't with Stage 1's.
 
You must log in or register to reply here.
Back
Top