Skunk2 tuner 2 cams


5

5MITHY

Member
Joined
Sep 22, 2010
Messages
64
Hi all,
Just after some advice on what I would need to get a set of skunk2 tuner2 cams working on my b16a2.. I've currently got:

Whales C*ck intake
Skunk 2 intake manifold
5zigen 4-2-1 exhaust header
Custom 2.5" - 60mm decat
Skunk 2 megapower cat-back..

There's a set of cam gears and camshafts for sale in the classifieds however I'm really not big into my 'inside engine components..' can someone tell me exactly what ill need to get them in and running? Hondata s300 and tuning will come after and setup will be done by a professional.. thanks all..

Dan
 
For Skunk2 Stage 2 Tuner Cams I think you'd need:

Adjustable Cam Gears (To degree them properly)
Uprated Valve Springs
Uprated Retainers
A tunable ECU
 
coler said:
the pro on b16 needs big cr.

they are not for a stok block.
Click to expand...

Pretty sure they will fit fine, someone made +16hp at the wheels (by advancing the intake by 2-3 degrees) with the pros with only basic mods on a b16a
 
e5k1m0 Sam said:
Pretty sure they will fit fine, someone made +16hp at the wheels (by advancing the intake by 2-3 degrees) with the pros with only basic mods on a b16a
Click to expand...

what he is trying to get at is, to optimise the cams potential you need a higher CR, not you cant run them on a stock block.
 
Ahh right I get you lol. If you're not looking got mess too much with the internals, then yeah I'd have the tuner over pro, although I've not seen any dyno graphs to compare the two. But bear in mind, the pro series has a much higher potential. And as DV8 said, get uprated valve springs and would also suggest titanium retainers for the stage 2s
 
got the pro 2,s and valve train in mine with really good porting job.. makes 217bhp on completely standard bottom end..tuned on hondata of course..
 
You must log in or register to reply here.
Back
Top