Spare Hole in Whale ***** Intake?

[Beanz]

Hi guys,

I've got a spare hole where the IAT sensor would go on some cars on my intake for my B18C which doesn't use it.

I've been searching around with zero luck as what to use to plug up the hole, it's 20mm in diameter, my first thought was a grommet of some sorts but I'm a bit paranoid about it getting sucked in, any suggestions?

Thanks,
Beanz

 

[Wazer]

Rocker cover breather pipe gets my vote.

 

[nicole_]

My tegiwa (i think it was) had two holes, one for breather pipe and another that I didnt have a use for
I bought one of those little packs of 5 grommets from halfords and one of them fit perfectly. took quite a lot of work getting it in so defo wasnt going anywhere to get sucked in

 

[rvm]

Rocker cover breather pipe gets my vote.

x2

 

[nicole_]

best pic I could find of mine

 

[b16 mini]

Rocker cover breather pipe gets my vote.

A lot of these intakes have two holes, so breather pipe probably already connects to one meaning the other is spare, guessing that's what the o-p means.
I would use a grommet as said, for piece of mind put a bit of super glue on the grommet

 

[oifovo]

Ehm, I just wrapped some gaffer tape around it lol, does the job just fine (just like you'd expect from gaffer tape!).
My motto: ..............If gaffer tape hasn't fixed it.......................... you should have used zip ties

 

[Murray]

The early B16s had a throttle pot on the throttle body that has a vac hose that goes into the inlet pipe.