bmwm3csl[ITA]
New Member
- Joined
- Jun 14, 2010
- Messages
- 8
Hello, i have a DC2 ITR 1998 B18C6 w I/E and i have bought a genuine spoon ecu P73 003.
After install i tried to do the reset after start up 10 minutes on idle, than turn off. again 1 minute on idle, turn off.
turn on and go...the idle is 1100 a bit too much for my tast but after that all right the engine seem to have better torque and response, BUT after a while the engine check light goes on, the engine still work well but there is no VTEC (also w the engine check off) i have tried to make other times the reset but it don't change, when i switch on the light is off and after a while it goes on.
reinstalling the stock ecu the problem is solved...but w the spoon it don't work
i have still not check the error
If anyone can help me i'll appreciate
thanks you very much
marco
After install i tried to do the reset after start up 10 minutes on idle, than turn off. again 1 minute on idle, turn off.
turn on and go...the idle is 1100 a bit too much for my tast but after that all right the engine seem to have better torque and response, BUT after a while the engine check light goes on, the engine still work well but there is no VTEC (also w the engine check off) i have tried to make other times the reset but it don't change, when i switch on the light is off and after a while it goes on.
reinstalling the stock ecu the problem is solved...but w the spoon it don't work
i have still not check the error
If anyone can help me i'll appreciate
thanks you very much
marco