Hi there guys I recently got my hands on an extra B16B T/B
and I have had it bored out to 66mm > 64mm Just want to think what you guys think will I loss a bit of Low - Mid Range torque ? since the size gone up quite a bit was going to get it machined 66mm>60mm any way lay it out there and see what you guys thinks
here is what I've done to my engine so far no Cams yet
Engine:
TRR 4>2>1 Headers
5Zigen Miracle Fireball 2 1/4" Cat back
Custom HPC'd intake with Simota Filter
Workshop X Carbon Airbox
MSD 8.5mm leads
Spoon Earthing kit
Spoon radiator cap
Exedy 5 Puck clutch
Lightened Flywheel
Innovative engine mounts black insert
Mugen Fan switch
Mugen Thermostat
and I have had it bored out to 66mm > 64mm Just want to think what you guys think will I loss a bit of Low - Mid Range torque ? since the size gone up quite a bit was going to get it machined 66mm>60mm any way lay it out there and see what you guys thinks
here is what I've done to my engine so far no Cams yet
Engine:
TRR 4>2>1 Headers
5Zigen Miracle Fireball 2 1/4" Cat back
Custom HPC'd intake with Simota Filter
Workshop X Carbon Airbox
MSD 8.5mm leads
Spoon Earthing kit
Spoon radiator cap
Exedy 5 Puck clutch
Lightened Flywheel
Innovative engine mounts black insert
Mugen Fan switch
Mugen Thermostat