Wheel size ideas


E

Ek4Mark12

New Member
Joined
Aug 23, 2013
Messages
11
Hi,

Still very new to honda and would like to purchase some new wheels.

I currently run rota grids but want to get some wide wheels to run a bit of rear camber.

Question is, what size fronts shall I get to sit flush and what size rear to sit flush with a touch extra camber?

Many thanks
 
Not sure about camber, but my wheels are 15 x 8' wide, +36 offset.

The backs sit flush, and the fronts stick out a little bit. But I have J's wings (extra 1.5cm wide), so they tuck under nicely.

So I guess, anything under +36 will stick out.... and can be adjusted to give you the camber.

:nice:
 
Ok, we'll I'm sticking with factory ek4 wings.

So best bet would be about 38-40 front offset?

And then rear I could go maybe lower to give extra width but then add stretch and camber?
 
Yea that sounds about right to me as I think OEM is something like +45, and they sit a little bit further in. :nice:

Although, my wheels are 8'' wide, I don't know how much of a difference that makes to how you work it out. Probably best getting a few opinions.
 
Ye I was wanting 8" and anymore is too much IMO.

Hopefully someone could show me what they run :)
 
I have Team Dynamics Pro Race 1.2 in both 15x7 and 16x7 et 35 I think and they fit well. Tbh I am thinking of adding slip on 5mm spacers to bring that down to et30, especially on the back at an attempt to get them as wide/flush as possible without any arch modification.
 
You must log in or register to reply here.
Back
Top