Recent content by DLO01

Quarter of a century!!!! :clap:

Ha ha, have not been on here for a while. Yeh, sold the turbo setup to a mate of mine. Looks like this now:

You cannot adjust camber Oem. You need ajustable camber arms front and rear. Get a wheel alignment. Or another solution is raise the car.

I perfer to take temperature from the sump. This is where it is going to be the hottest, so this is what I want to observe. However using a sandwich plate under the filter is the easiest way to fit the sensor and will also give you accurate results.

If you track your car an oil cooler is a good investment. If you only street drive. don't bother with a cooler, its not needed. A oil cooler setup 'will' lower your oil pressure. A simple law: Pressure will remain constant when there is no flow, but as soon as you introduce flow you...

Well cool then. :nice:

It does not matter what size radiator he is using. Your still got a water Thermostat and Fan switch. During normal street driving your thermostat will maintain and open/close to maintain low temps and your fan will switch on to control high temps. The benifit of a larger radiator is to better...

Thats sounds right for oil temp. Would be good to invest in a oil cooler for the track.

Yeh, thats right. 3 engine mounts and 2 torque mounts. Buy them seperately.

yeh, my thoughts exactly. Bunch of girls.

I have the 62A's in my ITR. After researching on the net, a lot of people complained about how much vibration these ones made. It really did not bother me, so I ended up getting the 62A's. After installing them I only noticed a little more vibration at idle and was not as bad as people...

AUDM ITR's came in PY CW NHB & MR To enter Tunerzine you need to enter a email address, is this what its asking? Is this the problem? This is my work log thread here on Ozhonda. Its got all the work done on the car since August 2006: Ozhonda Forums

Hey Guys, Dean here from Au. I am the owner of the car. Thanks for all the comments. Km's are genuine on the car and the artical written by Chris is factual in everyway (this is how I wanted it, no BS) and yes I have/do take a lot of pride in my work. I'm not here to convince anyone...