Recent content by ga's ek9

Could've been me. Mines a facelift, sianny's pre-facelift

iirc you have to click datalogging so it's actually communicating with the ecu before you can load a map

Havent long replaced mine out with this set. Best thing i ever did. Feels like a brand new box! As said tho, open it up just before ordering as mine needed 3/4th hub also.

Haha. x2! He wanted to keep the actual sack to sell on ebay to fund the operation. Maybe for someone to make a scrotie coat like randy made sharon in the episode. Quality!

It reminded me of the medicinal fried chicken episode of south park.

No. Had the site bookmarked from when i was doing my build. Didnt end up getting any machine work done so didnt end up contacting them. They look like they know their b series though

Tried these? http://www.tdp.ie/?page_id=74.com5

Does this actually work?

5-600 is a bit pricy tbh. Genuine honda clutches can be had for around 170 from hendy performance iirc. Not that hard to replace so looking at a couple of hours labour maybe.

It is a ek9 btw

Me 2. Saw it yesterday. Made my day. Lol

Lucky you. Ha. Good luck with the fix

Forgot gear linkage. Lol

Same here mate. Mines got a horrible rumbly noise. Noise suddenly appeared after clutch stuck down. Gearbox is piece of piss on ek. No subframe to worry about. Drain oil, shafts out, mounts off, disconnect wiring, starter out then bell housing bolts and out she comes. Might be a guide online...

I had exactly the same problem on way back from work yesterday except i had to make it 20 miles on motorway rush hour traffic. Not nice! I'd check for leaks from slave and master cylinder 1st or bleed the clutch to see if it gets any better. Failing that, i'd go for clutch pressure plate fault...