Search results

In need of a distributor in good working order

i have just rebuilt my bottom end with new shells and new piston rings. i have ran it for 15min then changed the oil and filter. then took it for a drive for about 20 minutes i used every gear and took 3rd and 4th gear to 4500 revs and deaccelerated to 2000 then did the same in 5th but went to...

can anyone help/ know where i can buy some of acl race conrod bearings for a ek9 thanks

I have just had my head rebuilt and bought a rebuilt b16b bottom end witch only coverd about 2000 miles. The head is a b18c4. an put it all back together an started it up. it now smokes i have so far done 230 miles since the rebuild and havnt gone above 4000rpm an havnt touch vtec. it only...

As title says in need of some.oem b16b flywheel bolts. And a passanger side driveshaft

just wont to know will itr valve an springs fit straght into a b18c4 head without having work done to the head ?

as title says if any has anything off the list please pm me valves valve springs and retainers set of cams

in the middle of rebuilding my engine i did have a b18c4 swap in my ek4 but the bottom end spun a shell. witch is why i got myself a b16b bottom end. i will be putting my b18c4 head with ctr valves and valvesprings onto a b16b bottom end. i have a skunk pro intake and a 98 spec teg manifold...

been looking on this forum a while and thought it was about time i put a couple of pictures up of my car,i have had the car for a while but its now off the road due to the bottom end. so re doing that over the winter along with a few other things spec list b18c4 conversion with...

i know the head will fit but would there be much point in putting this head onto the block or should i also get a ctr head? or maybe change the cams in my head for ctr cams?

need the bottom end in good condtion please