Search results

I managed to order a set of black diamond plain discs! Thanks for the options

Hi, I am hoping to upgrade the front brakes in my eg6 rallycar as one of the discs has a crack in it, i think i will go with carbon lorraine rc6 pads, mg zr 282mm discs and civic type r callipers. I am looking to find a set of front discs that are not drilled or grooved but capable of the...

Got the 1.8 integra crank and rods from him, excellent service and has great word. thanks

I pm'd you there, i will take them if they are still available. Thanks Damien

Could you pm me a price on engine, box, loom and ecu. Thanks

Fair piece of a car there!

Nice work there!

Very nice car!

Hello there, Aongus Power told me about you, would you be able to do me a price for the followin: Ek9 front left engine torque mount ek9 front and back red H emblem rear civic type r sticker for boot lid eg6 front left torque mount eg6 rear disks Thanks, Damien Boyle

Hello, I would like to get a set of blue silicone pipes for a b16a engine and a set(16) of red oem fit wheel nuts, i need them delivered to galway, ireland, can you pm me with a price and paypal payment info, Thanks, Damien

Hello, My address is dangan, tuam, co. galway ireland, will you do up the price and i will pay the deposit, also how will i pay you for it, paypal?

Hello there, Can you send the conrods and pistons to ireland? how will i pay you for them and how much of a deposet do you want? thanks, Damien Boyle

is it in it long? make sure the con rod bearing arnt gone...

I think you are right, i will go with one of these brands as i may put higher lift cams in sometime. i got oem honda oil rings today and will get a head set tomorrow, thanks for the info:nice:

i am currently buiding a b16a engine for rallying, i am using b16b cams and need valve springs and retainers to use with them. i have been looking at skunk 2 but they seem very pricey, what would be best to use? the engine will be reving to a max of 9000rpm

I am going to build my gearbox in my civic eg6 rallycar over the christmas, it has a kaaz lsd already in it, i have been looking into putting an mfactory gearkit and final drive into it, what i am trying to find out is: what is the difference in strength between the mfactory basic gears and the...

Is that for the full lights or the lenses?? i was hoping to get standard civic lights and swapping the lenses only as i would imagine they wud be the same and i would be able to get them queite cheap... i was hoping to do this as the rest of the headlamps are as new..

iv just bought a 00 civic type rx and the headlamps have lots of minature cracks in them. they cannot be taken iut if them by compound etc. as they go right through the lenses. What i am trying to figure out is can i take the lenses off a standard 99-00 civic and put them on my headlamps?? all...