Hytech Exhaust For Hatch


sustec is the suspension made by tanabe ( TANABE )
its good suspension.
 
Last edited:
Wow, very surprised how far it sits in the bumper, i would be pretty upset if that was me, have you asked john if thats normal?
 
Correct me if i'm wrong on this but that exhaust hanger at the twin loop is waay too long.The oem piece is a small rubber, smaller then the others...Couldn't you slide the twinloop more towards the rear ?These are slip-on fitments so if there's room i would do it.
 
Last edited:
Correct me if i'm wrong on this but that exhaust hanger at the twin loop is waay too long.The oem piece is a small rubber, smaller then the others...Couldn't you slide the twinloop more towards the rear ?These are slip-on fitments so if there's room i would do it.

Yes I Do believe that the hanger is to long

After I get the test pipe mounted im going to try to slide it out some
But I will be limited by the set nut
 
Finally got the New Test Pipe today Fit Like a glove!! Also Got the Tein Basics in and Skunk 2 lower Control Arms. Everything went together with little flaw. I am very pleased with the exhaust its very quit with just the right amount of noise while on throttle. Since this is my daily I went with Tein Basics for a Integra it rides perfect. When I installed the LCAs I came to find out that my rear sway bar end links did not have the right bolts for the LCA's so I didnt put the Rear Sway on. I will tackle this when I get back in town. I will also make a video of the exhaust. All and all I am very very pleased!!
DSCN0869.jpg

DSCN0870.jpg

DSCN0871.jpg

DSCN0872.jpg


New Vs. Old
DSCN0873.jpg

DSCN0874.jpg
 
I will make one when I get home as promised I am overseas right now so Ill make one in about a week :)
 
Where you able to set it up with the tip sticking out a bit more? Last pic shows it looking a bit short...
 
Sweet man! Some of the best stuff made for Honda's comes from John!
Do us a favor and post a sound clip! Please?
 
Last edited:
Back
Top