KiddFlow
Member
- Joined
- May 4, 2011
- Messages
- 93
Okay...I recently did an oil change and accidently topped it off a little too high (4.5l oil in total). Due to not having a JDM B18CR Service Manual I didnt know the exact amount. It read higher than i liked so i went and sucked a little oil out and all is fine in my book for now (drove roughly 60 miles with it topped off before reducing the amount). Like most, i like to double check for leaks after an oil change and noticed my oil pan gasket was a little oil soaked (not leaking, just black oil residue) all around the spot where the oil pan/sump meets the bottom block. like i said it is not a leak (i hope it does not turn into one) but there is evidence of oil residue (not from the recent change). The pan/sump was clean with no oil, only the seal around the pan/sump. I was told this is somewhat normal!?! Has anyone else experienced this? On my previous engine before the swap, i never had this issue. Currently the engine is still clean and oil is not getting low (unless burning off from Vtec). Any comments or concerns will help here. I dont like oil on my baby...