Skunk2 Ultra Street Inake manifold vs PerformerX


KRISTAPS

Member
Joined
Apr 26, 2013
Messages
94
Hello! I am searching info about these 2 Intake manifolds on B18C6! I want to know how perform these 2 Intake manifolds Skunk2 Ultra Street and Edelbrock PerformerX! Which one could be better on practically stock engine and if they really give some gains over stock TypeR intake manifold? Maybe can give opinion about this! Thanks! :)
 
I would say if stock, stick to your type r intake,
As a lot of RD went into that set up to get the most out of that engine, but if it's top end you want you might get a bit more from junk2 but at a cost to low end ,
Just leave it and spend the money on a good FD and lsd .
4.9 or whatever, and good rubber.
Basically, build your gearbox first, as there is more to gain from that ,
Then after that maybe bigger cams , then bigger intake ,
But others may say different,
 
I would say if stock, stick to your type r intake,
As a lot of RD went into that set up to get the most out of that engine, but if it's top end you want you might get a bit more from junk2 but at a cost to low end ,
Just leave it and spend the money on a good FD and lsd .
4.9 or whatever, and good rubber.
Basically, build your gearbox first, as there is more to gain from that ,
Then after that maybe bigger cams , then bigger intake ,
But others may say different,


OO, i thinked that too, that Honda engineers are worked and thinked to get best result from this engine! ;) But what about porting this manifold? It makes soe feelable diference? :)
 
Back
Top