- Joined
- Sep 27, 2015
- Messages
- 1,494
- Car(s)
- Ek9
I'm wanting to go wider at the front of my car and I was planning to run the pair of 16x7 that I have on the rear then get a pair of 16x8's for the front with an offset of 30 or lower
I would assume that these are 16x8 et20? I may be interested in 2 of your wheels if someone else wanted the fronts to run a staggered setup or even yourself? You could use a 15x7 or a 16x7 rota grid on the rear and even use extended studs and a hubcentric spacer to lower the offset of the 7" wheel a bit. I have rolled the rear arches neatly on the teg and can fit 16x7 et42 with 215 wide semi slicks and a 15mm spacer without any rubbing so that's at et27 on the rear
For the front wings, I have just finished rolling and pulling a bit and I made an aluminium plate to space the bottom of the wing out, then spacers where the wing attaches at the front to give good clearance
I think they're et20. That's the sticker on the wheels.
I think I'm just going to sell the wheels rather than use them now. Rookie mistake and impulse buy!
I've cleaned them up well and repaired the kerb mark now.
You're more than welcome to try them.
I'm at Combe end of the month of you're there I can bring one down?