Search results

Im after an ek9, must be in good condition. Got a red 7th gen celica 190. Very good condition, FSH. Full leather interior. Just fitted a new Sony touch screen double din head unit. Had alloys refurbed in pearl white about 2 weeks ago. So if anyone is interested in part exchange drop me a PM...

Right ive worked out that by the summer I could save up about 4k. Im just wondering for 4k could I pick up a decent ek9? I'll be sticking with my ek4 for another 6 months but trying to plan ahead. I could maybe at a push get 5k but thats 6 months of doing **** all other than working. Just...

After a ek9 spoiler + baseplate. Must be in VSM! Thanks :D

Did a B16A2 swap into an EJ9. Took it out for a drive and it all drove fine. Then suddenly it all bogged down, the car was shaking aggresively. Then couldnt rev the car past 3k. Also struggled to get the car into gear aswell! Got a video of it because its hard to explain. The car idles horribly...

Im after an EK4. Got roughly 2k to spend. If anyone is interested in a MKii Mazda MX5 as part exchange I'd be up for that :) will do car + cash your way

After some VSM side mirrors + door handles for my facelift EK

Done a b16a2 swap into an EJ9. Got a problem and unsure on what it might be so if anyone could help that would be great. Basically turn the car on it idles fine, however when I open the throttle the engine bog down and stalls? Its running on a p30 ECU. Am thinking about sending it to H-tune to...

After an ek9 inlet manifold. Also MAP sensor + tps sensor. Thanks!

Just curious, if I was to use b18c4 cams + inlet manifold on my b16a2 would it have much of a performance increase? Also would I need a remap?

No chips/cracks. Dont mind abit of fade laquer. better the condition the better :) let us know what you got

Im after a cambelt cover for my b16. Must be in good nick, no cracks or smashed. Cheers

Hey! Im after a p30 ECU + an obd2b to obd1 jumper harness. Any help would be great!!!

Fitting a b16a2 and i cant see to get the engine to line up with the engine mounts! is it usually this difficult? just wondering if anyone has any tips on what can make this job easier? cant work out why it wont fit! :confused:

Need the bit that joins from the Torque mount to the engine and the other that joins to the gearbox. Anyone got them?

Right putting a b16a2 into an EJ9 i bought an ek9 wiring loom, all the plugs match up except for the injectors. Is it possible to cut the plugs and wire it? or am i going to need ek9 injectors?

After front brace preferably a 3 point. Got a spoon rear strut brace to part exchange for one :)

Will it be ok to run a b16a2 with a ek9 ecu?

suitable for doing a b16a2 into EJ9. Let us know what you got, thanks!

Doing a b swap in a facelift EJ9. The b16a2 is out of an EG6 (obd1) So i got myself an obd2b wiring loom and a facelift EK4 ecu. All the plugs on the wiring loom fit except the dizzy so I would have to do abit of splicing to make it work. Would it be best to use an obd1 wiring loom and a...

Hey. Im after an EK9 distributor (obd2b) and some b-series engine mounts! give us a shout if you can help :)