Search results

Im looking for information about converting a b16b to run the other way so it can be used to power a mk2 escort rally car. It has been done before but I'm looking for info as to what has to be changed and is it expensive Thaks in advance

Well lads just wondering are ek9 panels like wings quater panels doors boot lids ever going be discontinued from Honda. Just curious as I have a ae86 as Well as a ek9 and 90% of the parts for a ae86 is discontinued from toyota

Anyone know the colour code for spoon calipers won a set in a raffle want to paint my back calipers the same

Looking for 4 ek9 centre caps in white anyone able to point me in the right direction priced new of Honda and the crazy money

Anyone ever refurbish there centre caps seen ones done with the red h in a sticker but want to no if anyone ever done the the way there out of the factory with a stencil to spray the h on

Are theses a good ecu to map a Honda on is the future such as launch control and shift light on them

Wonder is there anyone runnin a hydro in a Honda have a teg track car and was think bout using one but is there any point

Is mapping a car on a apexi neo a thing of the past on a budget and it's only a track car tat only be out couple a times a year

Quick question when installing a oil filter relocation kit does it have to be kept low like the ordinal filter or can it be mounted anywhere

Alternator is over charging what would be the cause of this. And also the power steering is heavy to one side is that got to do with the box that plugged into the rack 3 plugs go into it from the loom and one out to the rack

Lads put a b18c4 in a dc2 sir it's throwing up a flash code for the knock sencor I'm i right in saying there is no knock sencor on a b18c4

Car won't start took plugs out there covered in oil what would be causing this

Put a engine in my car it's swinging fuel coming out of the injectors and there's a spark but it won't fire anyone got any idea

Just after putting a engine in a integra track car when I went to swing it the braided hose on the clutch line started to smoke and got very hot only that pipe none of the pipes either side of it were hot. Anyone ever see anything like this happen before

The engine mount bracket that is on the timing belt side of my engine only has one hole but the mount I have has 3 holes can anyone shed some light on this for me first time putting in a engine any help much appreciated

As above anyone no where these can be bought

Best place to buy a Skunk 2 intake mani for a b18c4 new or second hand

Was wondering if a integrated type r intake manifold will make any difference on a b18c4

Are all the b18c engines the same torque settings I have a b18c4 wondering if the torque setting same as say a b18cr

Anyone ever spray there block and gearbox and tat to tidy it up if so how did you clean it and did you sand it down or what method did you use